Specifications

Page 2
Section 4.8
Service Training
4.8.1 MAST REMOVAL
- Remove the forks.
- Lower the fork carriage.
- Tilt the mast fully forward.
- Disconnect the hoses (6) on the fitting (7).
- Unscrew the overhead guard bearings on the left and right and slide the overhead guard back.
- Remove the left and right tilt cylinder pivots, tilt the cylinder up and secure it.
- Attach a rope to the top cross member of the outer upright and hook on a crane. Be sure that the load
capacity of the crane and rope is sufficient.
- Remove the mast pivot bearing pillows and lift the mast out of the pivots.
- Installation is the reverse of removal.
- Bleed the lift cylinders when taking the truck into operation again.
7 Fitting
8 Fork carriage
9 Cylinder mount
10 Washers
11 Washer
1 Retaining ring
2 Inner upright
3 Outer upright
4 Bracket
5 Lift cylinder
6 Hoses