Specifications

Service Training
Section 4.9
Page 8
12.05
- If there is no torque measuring tool (1) available,
mark the position of each individual screw on the
cylinder head in relation to a corner point (A).
- Mark the correct angle (in a clockwise direction)
on the top of each screw in accordance with
length (S, M or L).
- Tighten the screws in the correct order until they
are adjusted in accordance with the marks made
on the cylinder head.
WARNING It is not necessary to tighten the
cylinder head screws when the
motor is warm or after 50 hours of
operation.