Specifications

Page 22
Section 4.1
Service Training
09.06
4.1.2.3 REPLACEMENT OF V-RIPPED BELT
Fit the V-ripped belt and tension it.
Pressh the belt tensioner pulley (1) in direction of the
arrow. Fit the V-ripped belt, and finally place it on pulley
(2). Loosen the belt tensioner pulley in opposite direction
to the arrow until the V-ripped belt is tensioned.
If the V-ripped belt is used again, make sure to observe
the wear limit.
Measure the distance "a" between the lug of the movable
tensioning arm and the stop of the fixed tensioner housing.
If the distance "a" is less than 3 mm, the V-ripped belt must
be replaced.
The V-ripped belt is equipped with a spring-loaded belt
tensioner pulley that tensions automatically, and it is not
re-tightened.