Specifications

Page 34
Section 4.1
Service Training
09.06
INSTALLING THE CYLINDER HEAD
NOTE: Sealing surfaces for cylinder head gaskets must be clean and free of oil. Pay attention to the
fitting sleeve.
- Check the cylinder head for warping.
- Put the cylinder head in place.
- Check the cylinder head bolts for stretching, see "Visual check".
- Lightly the oil and screw in the cylinder head bolts.
NOTE: Use the cylinder head bolts no more than 5 times.
- Insert the push rods.
- Mount the rocker arm bracket.
- Slightly oil and screw in the long cylinder head bolts.
- Torque the cylinder head bolts as specified and according to the tightening sequence.
Pre-tightening: 1st step 30 Nm
2nd step 80 Nm
Retightening: 90°
CYLINDER HEAD BOLT TIGHTENING SEQUENCE
Manifold Side