Specifications

Page 42

Section 4.1

Service Training

09.06

- Siide sealing ring onto injection valve using some grease

and insert injection valve.

NOTE: The notch on the injection valve must face

away from the claw. Marking faces exhaust

gas end.

- Mount claws and tum in bolts loosely.

- Fit new injection line with sealing rubber. Tighten cap nut

finger-tight.

NOTE: Sealing cones must be exactly in line when

mounting the injection line.

Re-bending is not allowed. Injection lines

must not be used twice.

- Tighten bolt of claws.

Specified tightening torque: 16