Product Description

Develco Products assumes no responsibility for
any errors, which may appear in this manual.
Furthermore, Develco Products reserves the
right to alter the hardware, software, and/
or specications detailed herein at any time
without notice, and Develco Products does
not make any commitment to update the
information contained herein. All the trademarks
listed herein are owned by their respective
owners.
Distributed by Develco Products A/S
Tangen 6
8200 Aarhus
Denmark
All rights reserved.
IN ACCORDANCE WITH THE DIRECTIVES
• Radio Equipment Directive (RED)
2014/53/EU
• RoHS Directive 2015/863/EU amending
2011/65/EU
• REACH 1907/2006/EU + 2016/1688
CE certication
The CE mark axed to this product conrms
its compliance with the European Directives
which apply to the product and, in particular,
its compliance with the harmonized standards
and specications.
IC statement
ISED statement
Innovation, Science and Economic Develop-
ment Canada ICES-003 Compliance Label:
CAN ICES-3 (B)/NMB-3(B).
ISED statement
However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment o and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
This device complies with FCC RF radiation
exposure limits set forth for an uncontrolled
environment. Must not be co-located or
operating in conjunction with any other antenna
or transmitter.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interfer-
ence, and
2. this device must accept any interference
received, including interference that may
cause undesired operation.
Français
L’émetteur/récepteur exempt de licence
contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences
et Développement économique Canada
applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux
conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le
fonctionnement.
Cet équipement est conforme aux limites
d’exposition aux radiations IC CNR-102 établies
pour un environnement non contrôlé.
English
This device contains licence-exempt
transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference,
including interference that may cause
undesired operation of the device.
This equipment complies with IC RSS-102
radiation exposure limits set forth for an
uncontrolled environment.
FCC/IC SAR statement
English
This equipment has been tested and meets
applicable limits for radio frequency (RF)
exposure.
Speci
c Absorption Rate (SAR) refers to the
rate at which the body absorbs RF energy. The
SAR limit is 1.6 watts per kilogram in countries
that set the limit averaged over 1 gram of
tissue. During testing, device radios are set to
their highest transmission levels and placed in
positions that simulate use near the body,
with 0mm separation.
Cases with metal parts may change the RF
performance of the device, including its
compliance with RF exposure guidelines, in a
manner that has not been tested or certied.
Français
Cet équipement a été testé et respecte
les limites applicables d’exposition aux
radiofréquences (RF).
Le débit d’absorption spécique est la
vitesse à laquelle le corps absorbe l’énergie
radiofréquence. La limite du débit d’absorption
spécique est de 1,6 watt par kilogramme
dans les pays où la moyenne a été établie
sur un gramme de tissu. Pendant l’essai, les
radios de appareil sont réglées sur le niveau de
transmission maximal et sont placées dans des
positions simulant une utilisation à proximité du
corps, avec une séparation de 5mm.
Les étuis dotés de pièces métalliques peuvent
modier les performances des radiofréquences
de l’appareil, y compris sa conformité aux
directives d’exposition aux radiofréquences,
d’une façon qui n’a pas été testée ou certiée.