Specifications

PARTS REPLACEMENT/MAINTENANCE

CHART 1 – AIR CAPS

PART NO. FOR

AIR CAP

TECHNOLOGY

MARKING ON

AIR CAP

RECOMMENDED

INLET PRESSURE

AIR FLOW

(L/min)

COMM-100-HS1 HVLP HS1 29.0 psi (2.0 bar) 135

COMM-100-TS1 TRANS-TECH

TS1 29.0 psi (2.0 bar) 100

COMM-100-RS1 TRANS-TECH

RS1 14.0 psi (1.0 bar) 55

NOTE: When removing air cap from retaining ring, don’t remove the Slip Ring (2) or Retaining Ring Seal (5) from the

Retaining Ring. Damage to the parts may occur. Slip ring and Retaining Ring seal are not available as replacements.

Simply wipe parts clean and reassemble with new or clean air cap.

CHART 2 – FLUID NOZZLE RANGE & FLUID NEEDLE

PART NO. ON FLUID NOZZLE PART NO. NEEDLE

COMM-200-08

COMM-300-0810

COMM-200-10

COMM-200-12

COMM-300-1214

COMM-200-14

NOTE: When replacing the ﬂuid nozzle or ﬂuid needle, replace both at the same time. Torque to 70 in-lbs (8 Nm).

Don’t over tighten the ﬂuid nozzle. Use 6mm Spanner supplied with the gun and check with a torque wrench.

Page 13

SB-2-858-B