SB-E-2-252-I Operation Manual JGA – Suction Feed Spraygun E P2-8 1 © ITW Ltd 2001
E Operation Manual JGA – Suction Feed Spraygun Important Read and follow all instructions and Safety Precautions before using this equipment Description The JGA Suction Feed Spraygun Kit is suitable for use with most solvent based coating materials. Nozzles and Needles are available in Stainless Steel.
SAFETY WARNINGS E Gloves must be worn when s pra yin g or c leanin g th e equipment Fire and explosion Solvents and coating materials can be highly flammable or combustible when sprayed. ALWAYS refer to the coating material suppliers instructions and COSHH sheets before using this equipment Training – Personnel should be given adequate training in the safe use of spraying equipment.
E Parts List Ref.
E Chart 2. Nozzle and Needle Combinations Chart 1. Aircap and Nozzle Size combinations Aircap No Aircap Part Number FW 1.6 FF 1.4 EX 1.
E Installation Important: To ensure that this 2. Attach the Cup Lid assembly (27) to the Fluid Inlet connector (17). equipment reaches you in first class condition, protective coatings have 3. Position the Yoke at right angles to the Gun with the Cam lever to been used. Flush the equipment the front (see picture). Make sure through with a suitable solvent the vent hole in the lid is before use. positioned under the Yoke and 1. Attach air hose to connector (13).
E Preventative Maintenance metal wire which could damage 1. Turn off air and relieve pressure the cap and produce distorted in the supply lines, or if using QD spray patterns system, disconnect from airline. 2. Release Cup and raise the tube 5. Ensure the tip of the nozzle (2) is clean and free from damage. out of the material. Trigger the Build up of dried paint can distort Gun and allow material to drain the spray pattern. back into the cup. 3. Dispose of the surplus material 6.
ITW Finishing Systems and Products Ringwood Road, Bournemouth, BH11 9LH, England. Tel. No. (01202) 571111 Telefax No. (01202) 581940, Website address http://www.itweuropeanfinishing.com ITW Oberflächentechnik GmbH & Co. KG Justus-von-Liebig-Straße 31 63128 Dietzenbach Tel (060 74) 403-1 Telefax: (060 74) 403300 Website address http://www.itw-finishing.de ITW Surfaces Et Finitions 163-171 avenue des Auréats B.P. 1453 26014 VALENCE CEDEX FRANCE Tél.
