Electric Generator Operator's Manual

15- ENG
A04669
Air Filter
A dirty air cleaner will restrict air flow to
the carburetor and cause poor engine
performance. Inspect the filter each time
the engine is operated. Clean the filter
more frequently if the engine is operated
in very dusty areas.
NOTICE: Operating the engine without a
filter will allow dirt to enter the engine,
causing rapid engine wear. This type of
damage is not covered under the
warranty.
Cleaning
1. Remove the four screws securing
the sides of the panel and the two
fasteners with isolators securing the
bottom of the panel. Carefully
remove the panel noting that the
fuel filter and recoil starter will be
attached to the panel.
2. Remove the screws holding the
foam element in place.
Screws
Screws
Fasteners with isolators
3. Wash element in liquid detergent
and water. Air dry thoroughly.
4. Add clean engine oil to element and
press out excess, DO NOT wring or
twist element.
5. Replace element and secure in
place.
6. Replace and secure panel.
Screw
Screw
Foam
Element
Fuel Valve Bowl
Cleaning
1. Stop engine as described in the
Operation section.
2. Place the fuel valve lever in the OFF
position.
3. Remove the four screws securing
the sides of the panel and the two
fasteners with isolators securing the
bottom of the panel. Carefully
remove the panel noting that the
fuel filter and recoil starter will be
attached to the panel.
Screws
Screws
Fasteners with isolators