Installation guide

Security in the dLAN 47
devolo dLAN 200 AV Wireless N
The factory default password is
HomePlugAV. Assigning a specific
password to a single adapter will
exclude it from the remaining dLAN
network.
If dLAN Cockpit is called up again later after a suc-
cessful initial installation, for example to integrate a
new adapter into a network, the application remem-
bers the devices that were entered earlier. Enter the
new device as described in the Adding an adapter
section. The current network password is assigned
automatically to the newly added device.
5.1.2 dLAN network encryption at the
touch of a button
To encrypt a dLAN 200 AV network, in which all asso-
ciated devices are equipped with an encryption button,
simply press the encryption button that is located on
the device. Pressing this button will encrypt your dLAN
200 AV network with a randomly generated password.
The following section contains exact instructions on
the basis of possible network scenarios:
Encrypting a new network with a
dLAN 200 AV Wireless N and a dLAN 200 AVmini
(Fig. 1)
Once both adapters have been successfully connected,
press each encryption button for approx. one sec-
ond within two minutes of one another.
That's it! Your dLAN 200 AV network is now protected
against unauthorised access.