Technical data

devolo dLAN 200 AV software

devolo dLAN 200 AVpro i

If a device that has been switched off (e.g. a computer) is connected to the Eth-

ernet port, a dLAN 200 AVpro i device switches to Power Save mode after about

20 minutes. In Power Save mode, the dLAN

200 AVpro i device cannot be

accessed via the power supply grid or the coaxial network. As soon as the device

that is connected to the Ethernet port is switched on again, your

dLAN

200 AVpro i is available again via the power grid or the coaxial network.

햴 In the following dialog box, select a shared identifier for your

dLAN

200 AVpro i network, and click Next to confirm.

The default identifier set by devolo is HomePlugAV (note upper and lower

cases).

햵 The dLAN 200 AVpro i that is connected directly to your computer will be

found automatically. All other dLAN

200 AVpro is must be registered man-

ually. To do this, enter the Security IDs of the dLAN 200 AVpro is that are to

be combined in a network one after the other, and click on Add. Click Next

to confirm when you have entered all the dLAN

200 AVpro is you wish to

add.

햶 To exit the Security setup for your network, click on Finish. All the

dLAN

200 AVpro i adapters that are entered in the list will receive the same

ID. All dLAN

200 AVpro i adapters that have the same ID can exchange data

among themselves. Adapters that have been installed on the same power

supply grid or coaxial network, but which use different IDs, cannot commu