Technical data

TV and radio programme 29
devolo dLAN TV SAT Receiver Kit
햵 The dLAN TV SAT to IP Receiver loads the satellite
and transponder list. Select a satellite.
햶 You end installation by scanning for channels. The
installation assistant offers you different options
for channel scanning:
쎲 Load pre-programmed list: load the channel list
prepared by devolo.
쎲 Start regular search: the selected satellite is
scanned.
쎲 Search Astra service list: the channel list infor-
mation is downloaded from the satellite and the
channels sorted by LCN data.
You cannot move the channels using this op-
tion.
This scan process will take a few minutes. You can fol-
low the scan progress on the display bar. The scan re-
sults are then displayed.
4.2 Menu structure and operation
All settings are selected via the menu in the
dLAN TV SAT to IP Receiver using the remote control:
쎲 The layout of the remote control buttons and keys
is explained clearly in Section 5.3 The devolo
remote control.
쎲 You press the MENU button to access the main
menu.
쎲 Use the arrow keys to switch between selection
options or control buttons.
쎲 Press OK to confirm a value or activate a control
button.
쎲 Pressing MENU/BACK again takes you back to
the previous menu or quits the Menu. The soft-
ware returns to the TV display.
쎲 All the functions or options available for the cur-
rent menu are explained at the bottom of the
screen.
The section below provides a summary of the TV and
radio functions. When you switch your receiver on, the
software starts with the last selected TV or radio pro-
gramme.