Home Control Door/Window Contact first steps
Thank you for placing your trust in this devolo product. Carefully read all instructions before setting up the device and store the instructions for later reference. Icons Very important note. Failure to observe this note may result in damage. Important note that should be observed. Background information and configuration tips for your device. Intended use Use the Home Control Door/Window Contact as described in these instructions and in the Home Control online help to prevent damage and injuries.
devolo Home Control Home Control (also known as home automation) refers to the specific control of electrically operated indoor household devices. The Home Control system by devolo uses the Z-WaveTM wireless standard. A Home Control system requires a Z-WaveTM-compatible control unit such as the Home Control Central Unit from devolo. Use its Home Control portal to coordinate the Home Control Door/Window Contact and all other Home Control devices.
The Home Control Door/Window Contact The Home Control Door/Window Contact consists of a contact and a magnet. It sends information on the open or closed state of a door or window. It also cooperates with other Home Control devices. For example, an open window can automatically shut off the heat radiator in the same room. In addition, the integrated light and temperature sensors can act as initiators for the light controls.
Batteries Always keep batteries away from open flame and high temperatures. Avoid direct sunlight and heat radiation! Always remove all batteries from battery-operated devices that are only in storage and are not in use. Old batteries can leak and damage the device! Do not use rechargeable batteries! When inserting the battery, make sure the polarity is correct.
When you plug in the Home Control Central Unit from devolo, follow the description in the section devolo Home Control on page 3 to call up your Home Control Central Unit and select Devices Add device devolo Home Control Door/Window Contact. Follow the instructions in the Home Control portal for logging into your Home Control Central Unit.
If using the double-sided tape to fasten the Home Control Door/Window Contact, adhere the wider tape strip to the back of the sensor in the middle (below the release button) and attach the sensor to the desired location, for example, on the window or door. Then adhere the narrow tape strip to the back of the magnet in the middle and fasten this at a dis- tance of < 2 cm from and centred with respect to the sensor, e.g. on the window frame or door frame.
If you use screws to attach the Home Control Door/Window Contact, take apart the upper and lower housing components of the sensor by pressing the tab down components (from top to bottom, and ). in order to release the housing 쑗 Take apart the upper and lower housing parts of the magnet, starting at the groove provided for this purpose at the lower end of the magnet. If installing to a wall using screws, make sure that no gas, water or power lines in the wall get damaged.
쑗 Based on the template on the lower housing component of the magnet, drill holes into the window frame or door frame and then attach the lower component of the magnet using screws. Position the magnet in the middle, at a distance < 2 cm from the sensor. The notches on the magnet and of the sensor should line up with one another.
Service and warranty Warranty: 3 years If your devolo device is found to be defective during initial installation or within the warranty period, please contact the vendor who sold you the product. The vendor will take care of the repair or warranty claim for you. The complete warranty conditions can be found at www.devolo.com/warranty. Great Britain 0203 024 18 38 (national rate) support@devolo.co.uk Sweden 0077 1400 480 (national rate) support@devolo.
40959/0115 devolo AG Charlottenburger Allee 60 52068 Aachen – Germany www.devolo.
