Product Overview

TECHNICAL GUIDE – MECHANICAL ANCHORS ©2021 DEWALT – REV. C
A
NCHORS & FASTENERS
INSTALLATION INSTRUCTIONS
Mechanical anchors
3
INSTALLATION INSTRUCTIONS
Hex/Acorn/Flat Head Round Versions Rod Hanger Version Tie-Wire Version
Using the proper diameter
bit, drill a hole into the
base material to a depth of
at least 1/2" or one anchor
diameter deeper than the
embedment required.
The tolerances of the
drill bit used must meet
the requirements of ANSI
Standard B212.15
Using the proper diameter
bit, drill a hole into the
base material to a depth of
at least 1/2" or one anchor
diameter deeper than the
embedment required.
The tolerances of the
drill bit used must meet
the requirements of ANSI
Standard B212.15
Using the proper diameter
bit, drill a hole into the
base material to a depth of
at least 1/2" or one anchor
diameter deeper than the
embedment required.
The tolerances of the
drill bit used must meet
the requirements of ANSI
Standard B212.15
Remove dust and debris
from the hole during
drilling (e.g. dust extractor,
hollow bit) or following
drilling (e.g. suction,
forced air) to extract
loose particles created
by drilling.
Remove dust and debris
from the hole during
drilling (e.g. dust extractor,
hollow bit) or following
drilling (e.g. suction,
forced air) to extract
loose particles created
by drilling.
Remove dust and debris
from the hole during
drilling (e.g. dust extractor,
hollow bit) or following
drilling (e.g. suction,
forced air) to extract
loose particles created
by drilling.
Hex Head/Acorn Nut
Position the washer on
the anchor and thread on
the nut.
Drive the anchor through
the fixture into the anchor
hole until the nut and
washer are firmly seated
against the fixture. Be sure
the anchor is driven
to the required
embedment depth.
Drive the anchor into the
hole until the anchor is at
the required embedment
depth.
Drive the anchor into the
hole until the head is
firmly seated against the
base material. Be sure
the anchor is driven to
the required embedment
depth.
Flat Head/Round Head
Drive the anchor through
the fixture until the anchor
is firmly seated. Be sure
the anchor is driven to
the required embedment
depth.
Tighten the coupler nut
and washer up to the
concrete surface and
tighten the anchor by
turning the nut 3 to 5
turns past finger tight
or by applying the guide
installation torque from the
finger tight position.
Tighten the tie wire nut
by turning the head 3 to
5 turns past finger tight
or by applying the guide
installation torque from the
finger tight position.
Hex Head/Acorn Nut
Tighten the anchor by
turning the nut or head 3
to 5 turns past finger tight
or by applying the guide
installation torque from the
finger tight position.
Flat Head/Round Head
Tighten the anchor by
turning the head 3 to 5
turns past finger tight.