Instruction manual

Fig. 19

Fig. 20

Fig. 21

Fig. 22

ASSEMBLING MOTOR

PULLEY, BELT AND

PULLEY GUARD, AND

DRIVE BELT

WARNING: WHEN ASSEMBLING MOTOR PULLEY,

BELT AND PULLEY GUARD, AND DRIVE BELT, MAKE

CERTAIN THE MOTOR IS DISCONNECTED FROM

THE POWER SOURCE.

1. Remove the motor shaft key that is taped to the

motor.

2. Insert the key (A) Fig. 19, in the keyway on the motor

shaft. Assemble the motor pulley (B) on the motor shaft

as shown, with the hub of the pulley facing out. Tighten

set screw (C) against key (A) in motor shaft.

3. Remove wing nut and external tooth lockwasher (D)

Fig. 20, and outer cover (E) from belt and pulley guard (G).

4. Slide the belt and pulley guard bracket (G) Fig. 21,

between the motor plate (M) and motor mounting plate

(L), as shown.

5. Position belt and pulley guard bracket (G) Fig. 22, so

the motor pulley (B) is centered and through the hole in

the belt and pulley guard bracket, as shown. Tighten the

four hex nuts that fasten the motor to the motor mount-

ing plate.

6. Using a straight edge, align the motor pulley with the

arbor pulley. If necessary, adjust the motor pulley (B)

Fig. 22, in or out on the motor shaft.