Instruction manual

Fig. 54

Fig. 55

Fig. 56

Fig. 58Fig. 57

ASSEMBLING UNIFENCE

TABLE TO SAW

1. Position table board (A) Fig. 54, onto angle brackets

(B).

2. While holding table board firmly against the saw

table, fasten table to three angle brackets (B) Fig. 55,

using three #8 x 7/8 long wood screws (C). CAUTION:

DO NOT OVER-TIGHTEN TABLE MOUNTING

SCREWS. Over-tightening screws in particle board may

cause them to strip.

3. Using a straight edge (D) Fig. 56, make certain the

surface of the Unifence table (A) is level with the saw

table (F) by adjusting the height of the two leveling

screws (E) Fig. 57, at the base of the table legs and

adjusting the height of angle brackets (B) Fig. 58 and

tighten hex nuts (G). Position hex nuts (H) Fig. 57,

against the bottom of the table legs to hold the leveling

screws in position and tighten. Make sure the Unifence

table is level with the saw table.