Use and Care Manual

English

This warranty does not cover the following: machines used for

rental purposes, damage resulting from shipping (claims must be

filed with freighter), accident, abuse, act of God, misuse, or neglect.

Neither is damage from repairs or alterations performed by non-

factory authorized personnel or failure to install and operate equipment

according to the guidelines put forth in the instruction manual.

The manufacturer will not be liable to any persons for consequential

damage, for personal injury, or for commercial loss.

HIGH PRESSURE PUMP (DEFECTS IN MATERIAL AND

WORKMANSHIP)

One (1) year from date of purchase.

WARRANTY DOES NOT APPLY TO FAILURES DUE TO:

• Freightdamage

• Freezedamage

• Damage caused by parts or accessories not obtained from an

authorized dealer or not approved by the manufacturer.

• Normalwearofmovingpartsorcomponentsaffectedbymoving

parts.

FRAME (DEFECTS IN MATERIAL AND WORKMANSHIP)

One (1) year from date of purchase.

ACCESSORIES (DEFECTS IN MATERIAL AND

WORKMANSHIP)

Includes nozzles, hoses, spray guns, wands

Ninety (90) days from date of purchase.

Glossary

Bypass mode: Allows water to re-circulate within pump when the gun

trigger is not pulled.

Chemical hose: Feeds cleaning agents into the pump to mix with the

water. Refer to Chemicals and Cleaning Solvents.

Chemical injection system: Mixes cleaners or cleaning solvents with

water to improve cleaning effectiveness.

CU: Cleaning Units. GPM multiplied by psi. (GPM x PSI = CU)

GPM: Gallons Per Minute. The unit of measure for the flow rate of

water.

PSI: Pounds per Square Inch. The unit of measure for water pressure.

Also used for air pressure, hydraulic pressure, etc.

kPa (kilopascal): Metric pressure measurement. 1 kilopascal equal

1000 pascals.

Quick-connect spray wand: Allows the user to quickly change out

high-pressure nozzles. Refer to Spray Wand Nozzles.

Thermal relief valve: When the temperature inside the pump rises

too high the valve will open and release a gush of water in an effort

to lower the temperature inside the pump. The valve will then close.

Water supply: All pressure washers must have a source of water. The

minimum requirements for a water supply are 20 psi (138kPa) and

5gallons per minute.