Instruction manual

English

Inserting and Removing a Bit (Fig. 1)

KEYED CHUCK

1. Open the chuck by turning the sleeve (I) counterclockwise and

insert the bit shank.

2. Put the chuck key (J) into each hole in the side of the chuck and

turn clockwise until tight.

To remove the bit, proceed in reverse order.

Fitting the Side Handle (Fig. 1)

The side handle (F) can be fitted to suit both right-hand and left-

hand users.

WARNING: Always use the drill with the side handle properly

assembled.

1. Loosen the side handle.

– For right-hand users, slide the side handle clamp over the

collar behind the chuck, handle at the left.

– For left-hand users, slide the side handle clamp over the collar

behind the chuck, handle at the right.

2. Rotate the side handle to the desired position and tighten the

handle.

Setting the Drilling Depth (Fig. 3)

1. Insert the required drill bit into the chuck.

2. Slacken the side handle (F).

3. Fit the depth adjustment rod (G) through the hole in the side

handle clamp.

4. Adjust the drilling depth as shown.

5. Tighten the side handle.

Forward/Reverse Slider (Fig. 1)

To select forward or reverse rotation, use the forward/reverse

switch (C) (see arrow on tool).

FIG. 2

Selecting the Operating Mode (Fig. 2)

The tool can be used in two operating modes:

Rotary drilling:

for steel, wood and plastics.

Percussion drilling:

simultaneous rotating and impacting for concrete and

masonry drilling operations.

Select the required operating mode by rotating the mode selector

(D) to the required position.