Operation Manual

ENGLISH
5
• In operation, avoid bouncing the wheel or
giving it rough treatment. If this occurs, stop
the tool and inspect the wheel for cracks or
flaws.
• Clean your chop saw periodically following the
procedure in this manual.
• Never use the machine without the guards in
place.
• Do not remove base.
• ALWAYS USE THE VISE OR SPECIAL
FIXTURE TO CLAMP WORK SECURELY.
Other aids such as spring, bar, or C-clamps
may be appropriate for certain sizes and shapes
of workpiece. Use care in selecting and placing
these clamps and make a dry run before
making a cut.
• Use only 355mm (14") type 1 wheels rated at
4100rpm or higher.
• Allow cut off parts to cool before handling.
• Do not attempt to cut wood or plastic with this
tool.
• NEVER CUT MAGNESIUM WITH THIS
TOOL.
• Use chop saw in a well-ventilated area.
• Turn chop saw off before removing any pieces
from the base.
• DO NOT CUT ELECTRICALLY LIVE
MATERIAL.
• Do not use circular saw blades or any
other toothed blades with this tool. Serious
injury may result.
• DO NOT OPERATE THIS TOOL NEAR
FLAMMABLE LIQUIDS, GASES OR DUST.
Sparks or hot chips from cutting or arcing motor
brushes may ignite combustible materials.
• Ensure that the abrasive wheel is correctly fitted
and tightened before use.
• Let the tool run at no-load in a safe position
for at least 1 minute. If there is a considerable
vibration or if any other defect occurs, stop the
tool and check it to determine the cause.
• Ensure that ventilation slots are kept clear when
working in dusty conditions. First disconnect the
machine from the mains supply then clean the
openings by using a soft brush.
• Do not use the side of the abrasive wheel as a
deburring grinder. This will substantially weaken
the wheel creating an unsafe condition. The
wheel may come apart.
• The wheel continues to rotate after the machine
is switched off.
WARNING: Wear appropriate
hearing protection during use. Under
some conditions and duration of use,
noise from this product may contribute
to hearing loss.
CAUTION: Spark deflector will get hot.
Avoid touching or adjusting while hot.
Keep cordset and materials away from
spark deflector.
• Avoid prolonged contact with dust from
cutting activity Wear protective clothing
and wash exposed areas with soap and
water. Allowing dust to get into your mouth,
eyes, or lay on the skin may promote absorption
of harmful chemicals.
• Do not use toothed blades.
• Do not expose to rain or use in damp locations.
• Only use chop saw wheel of a
max. Thickness of 2.8mm and a
max. Diameter of 355mm (14").
Residual Risks
• The following risks are inherent to the use of
these machines:
– Injuries caused by touching the rotating
parts.
– Injuries caused by disruption of the cutting
disc.
• These risks are most evident:
– Within the range of operation.
– Within the range of the rotating machine
parts.
• In spite of the application of the relevant
safety regulations and the implementation of
safety devices, certain residual risks cannot be
avoided. These are:
– Impairment of hearing.
– Risk of accidents caused by the uncovered
parts of the rotating cutting disc.
– Risk of injury when changing the disc.
– Risk of squeezing fingers when opening the
guards.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.