Instruction manual

A GROUNDED B C
GROUNDING
BOX MEANS
GROUNDING PIN
ADAPTER
properly grounded outlet can be installed by a qualified electrician,
The green-colored rigid ear, tug, and the like, extending from the
adapter must be connected to a permanent ground such as a
properly grounded outlet box.
The adapter (C) is not for use in Canada.
DEWALT does not recommend the use of extension cords. This
can create power loss and overheating of the motor. Use an
additional air hose rather than an extension cord. If use of an
extension cord is unavoidable, it should be plugged into a GFCI
found in circuit boxes or protected receptacles. When using an
extension cord, observe the following.
Extension Cord Chart
1 Hp Motor
Rating Length of Cord in Feet
25' 50' 100'
12 amp, 115V 14 Ga. 12 Ga. 10 Ga.
2 Hp Motor
Rating Length of Cord in Feet
25' 50' 100'
15 amp, 115V 14 Ga. 12 Ga. 8 Ga.
RISK FROM FLYING OBJECTS
The compressed air stream can cause soft tissue damage to
exposed skin and can propel dirt, chips, loose particles and small
objects at high speed, resulting inserious injury.Always wearANSI
Z28.1 approved safety glasses with side shields when using the
compressor. Never direct air stream at people or animals. Use only
OSHA approved air blow guns.
RISK TO BREATHING
The compressed air from your compressor is not safe
for breathing! The air stream may contain carbon
monoxide, toxic vapors or solid particles. Never inhale
air from the compressor either directly or from a
breathing device connected to the compressor.
Sprayed materials such as paint, paint solvents, paint
remover, insecticides, weed killers, etc. contain harmful vapors and
poisons. NOTE: Operate air compressor only in a well ventilated
area. Read and follow the safety instructions provided on the label
or safety data sheets for the material you are spraying. Use a
NIOSH/MSHA approved respirator designed for use with specific
application.
RISK FROM MOVING PARTS
The compressor cycles automatically when the
pressure switch is in the ON/AUTO position. Always
turn off the compressor, bleed pressure from the air
hose and tank, and disconnect from power source
before performing maintenance or attaching tools
and accessories.
Keep your hair, clothing, and gloves away from moving parts. Loose
clothes, jewelry, or tong hair can be caught in moving parts. Air
vents may cover moving parts and should be avoided as welt. Do
not remove the protective covers from this product. Never operate
compressor with guards or protective covers that are damaged or
removed. Never stand on the compressor.
RISK OF BURNS
Touching exposed metal such as the compressor head or aftercooler
can result in serious burns. Never touch any exposed metal parts