Instruction manual

10
6. Use a slow speed to start the hole and accelerate by squeezing the trigger harder
when the hole is deep enough to drill without the bit skipping out.
DRILLING IN MASONRY
When drilling in masonry, use carbide tipped bits rated for masonry drilling. Be certain
that the bit is sharp. Ensure that the hammer mode is selected. Use a constant and
firm force on the tool to drill most effectively. A smooth, even flow of dust indicates
the proper drilling rate.
MAINTENANCE
Cleaning
CAUTION: Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap.
CHARGER CLEANING INSTRUCTIONS
WARNING: Disconnect the charger from the AC outlet before cleaning. Dirt
and grease may be removed from the exterior of the charger using a cloth or soft
non-metallic brush. Do not use water or any cleaning solutions.
Lubrication
Your tool was properly lubricated before leaving the factory. In from two to six
months, depending upon use, take or send your tool to an authorized service
center for a complete cleaning, inspection and lubrication. Tools used constantly on
production jobs will need relubrication more often. Also, tools “out of service” for
long periods should be relubricated before being put back to work.
ACCESSORIES
Recommended accessories for use with your tool are available at extra cost from your
local service center. If you need any assistance in locating any accessory, please
contact DEWALT Industrial Tool Co., 20 Fletcher Road, Mooroolbark, VIC 3138
Australia or call 1800 654 155 or (NZ) 09 526 2556.
CAUTION: The use of any other accessory not recommended for use with this tool
could be hazardous.
MAXIMUM RECOMMENDED CAPACITIES
DC232-XE, DC233-XE, DC234-XE
R.P.M. 0-1,150
B.P.M 0-4,400
BITS, MASONRY DRILLING 2.54 cm (1")
Repairs
The charger is not user serviceable. There are no user serviceable parts inside the
charger. Servicing at an authorized service center is required to avoid damage to static
sensitive internal components.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustments
should be performed by a DEWALT factory service center, a DEWALT authorized
service center or other qualified service personnel. Always use identical replacement
parts.
Guarantee
Applicable to hand held Power Tools, Lasers and Nailers.
Three Year Limited Warranty
DEWALT will repair, without charge, any defects due to faulty materials or workman-
ship for three years from the date of purchase. Please return the complete unit, trans-
portation prepaid, to any DEWALT Service Centre, or any authorised service station.
For warranty repair information, call (AUS) 1800 654 155 or (NZ) 09 526 2556.
This warranty does not apply to
• Accessories
• Damage caused where repairs have been made or attempted by others.
• Damage due to misuse, neglect, wear and tear, alteration or modification.
This warranty gives you specific legal rights and you may have other rights under the
provisions of the Consumer Guarantee Act 1993 (New Zealand only), Trade Practices
Act 1974 and State Legislation (Australia only).
In addition to the warranty, DEWALT tools are covered by our:
FREE ONE YEAR SERVICE CONTRACT
DEWALT will also maintain the tool for free at any time during the first year of
purchase. This includes labour, parts and lubrication required to restore the