Instruction manual

12
5. Make sure blade is not in contact with cutting surface before starting saw.
6. Start the motor and gradually lower the saw until its shoe rests flat on the
material to be cut. Advance saw along the cutting line until cut is completed.
7. Release trigger and allow blade to stop completely before withdrawing the blade
from the material.
8. When starting each new cut, repeat as above.
FIG. 15
M
MAINTENANCE
Cleaning
WARNING: When cleaning, use only mild soap and a damp cloth on plastic parts.
Many household cleaners contain chemicals which could seriously damage plastic.
Also, do not use gasoline, turpentine, lacquer or paint thinner, dry cleaning fluids or
similar products which may seriously damage plastic parts. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Disconnect the charger from the AC outlet before cleaning. Dirt and
grease may be removed from the exterior of the charger using a cloth or soft non-
metallic brush. Do not use water or any cleaning solutions.
Lubrication
Self lubricating ball and roller bearings are used in the tool and relubrication is not
required. However, it is recommended that, once a year, you take or send the tool to a
certified service center for a thorough cleaning, inspection, and lubrication of the gear
case.
ACCESSORIES
Recommended accessories for use with your tool are available at extra cost from your
local service center. If you need any assistance in locating any accessory, please con-
tact DEWALT Industrial Tool Co., 20 Fletcher Road, Mooroolbark, VIC 3138 Australia or
call 1800 654 155 or (NZ) 09 526 2556.
CAUTION:The use of any other accessory not recommended for use with this tool
could be hazardous.
Repairs
This charger is not user serviceable. There are no user serviceable parts inside the
charger. Servicing at an authorized service center is required to avoid damage to static
sensitive internal components.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustments
should be performed by a DEWALT factory service center, a DEWALT authorized
service center or other qualified service personnel. Always use identical replacement
parts.
Guarantee
Applicable to hand held Power Tools, Lasers and Nailers.
Three Year Limited Warranty
DEWALT will repair, without charge, any defects due to faulty materials or workman-
ship for three years from the date of purchase. Please return the complete unit, trans-
portation prepaid, to any DEWALT Service Centre, or any authorised service station.
For warranty repair information, call (AUS) 1800 654 155 or (NZ) 09 526 2556.
This warranty does not apply to
• Accessories
• Damage caused where repairs have been made or attempted by others.
• Damage due to misuse, neglect, wear and tear, alteration or modification.
This warranty gives you specific legal rights and you may have other rights under the
provisions of the Consumer Guarantee Act 1993 (New Zealand only), Trade Practices
Act 1974 and State Legislation (Australia only).