Use and Care Manual
8
English
• To removethe tube,insert a screwdriverinto the unlockinghole
(3D) on the side of the housing. Lift the tab inside and pull tube out.
WARNING: Do not operate blower without tube
securely in place. Never reach down into housing through tube hole.
WARNING: Always remove the battery when:
• You leave blower unattended and when storing.
• Checking, adjusting, cleaning, or working on blower.
To install battery pack: Insert battery pack (F) into battery housing
(E) as shown in Figure 4 until fully seated and an audible click is heard.
Make sure battery pack is fully seated and fully latched into position.
To remove battery pack: Depress the battery release button (G) in
the top of the battery housing and pull battery pack out of appliance
as shown in Figure 5.
FIG. 4
F
E
FIG. 5
G
Some DeWALT battery packs include a fuel gauge which consists of
three green LED lights that indicate the level of charge remaining in the
battery pack.
A. Variable speed trigger E. Battery housing
B. Speed lock lever F. Battery pack
C. Handle G. Battery release button
D. Tube
F
E
D
A
FIG. 2
C
B
G
CAUTION: Ensure the battery is removed before
attaching or removing the tube (D). The tube must be attached to the
housing (3A) before use.
• TUBE ASSEMBLY: To attach the tube to the blower, line up the
FIG. 3
D
3A
3B
3C
3D
pegs (3B) on the bottom of the
tube with the notch (3C) on the
bottom of the housing opening as
shown in figure 3. Push the tube
into the blower housing until the lock
engages the tube and an audible
click is heard.
• Pullonthetubetoensureitissecurely
in place.