Use and Care Manual

11
installing attachments or accessories. An
accidental start-up can causeinjury.

WARNING: Before each use, inspect the tool
(including LED indicators) and correct any
problems before attempting to use.

WARNING: Skin injection hazard. The oil in the
mechanism is under extreme pressure. Do not
use hands to check for oil leaks.

WARNING: Explosion hazard. The internal
hydraulic system creates extreme pressures.
Only
DeWALT
-qualified personnel should service
thistool.
Required Maintenance (Fig. A)
Maintenance is required when the pipe pressing tool
reaches 45,000 cycles. Warning indicators will illuminate on
the diagnostic panel
7
as follows.
1. Maintenance warning at 44,500 cycles (Maintenance
LED lights yellow continuously)
2. Final maintenance warning at 44,900 cycles
(Maintenance LED flashes yellow continuously)
3. Needs service at 45,000 cycles (Maintenance LED lights
red for 10 seconds then turns tool off automatically).
At 45,000 cycles, the tool will no longer run. Take your
tool to a
DeWALT
factory service center for maintenance
andrecalibration.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performingthis.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into aliquid.
Regularly clean the press jaws to be sure they are free of dirt
and debris to ensure a proper press.
Accessories

WARNING: Since accessories and attachments, other
than those offered or recommended by
DeWALT
,
have not been tested with this product, use of such
accessories or attachments with this tool could be
hazardous. To reduce the risk of injury, only
DeWALT
recommended accessories and attachments should
be used with thisproduct.
Recommended accessories and attachments for use with
your tool are available at extra cost from your local dealer or
authorized service center. If you need assistance in locating
any accessory or attachment, please contact
DeWALT
Industrial Tool Co., 701East Joppa Road, Towson, MD 21286,
call 1-800-4-
DeWALT
(1-800-433-9258) or visit our website:
www.dewalt.com.
For a complete and most up to date list of compatible jaws,
rings, attachments and fittings, visit www.dewalt.com.
Repairs
The charger and battery pack are notserviceable.

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a
DeWALT
factory service center
or a
DeWALT
authorized service center. Always use
identical replacementparts.
Register Online
Thank you for your purchase. Register your product nowfor:
• WARRANTY SERVICE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with yourproduct.
• CONFIRMATION OF OWNERSHIP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
ofpurchase.
• FOR YOUR SAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
SafetyAct.
Register online at www.dewalt.com/register.
Three Year Limited Warranty
DeWALT
will repair, without charge, any defects due to
faulty materials or workmanship for three years from the
date of purchase. This warranty does not cover part failure
due to normal wear or tool abuse. For further detail of
warranty coverage and warranty repair information, visit
www.dewalt.com or call 1-800-4-
DeWALT
(1-800-433-9258).
This warranty does not apply to accessories or damage
caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and
you may have other rights which vary in certain states
orprovinces.
In addition to the warranty,
DeWALT
tools are covered
byour:
1 YEAR FREE SERVICE
DeWALT
will maintain the tool and replace worn parts
caused by normal use, for free, any time during the first year
afterpurchase. The press tool wear items such as rollers,
roller pins, and roller holder are not covered.
2 YEARS FREE SERVICE ON DEWALT BATTERY PACKS
DC9071, DC9091, DC9096, DC9182, DC9280, DC9360, DCB120,
DCB127, DCB201, DCB203, DCB203BT, DCB207, DCB361
3 YEARS FREE SERVICE ON DEWALT BATTERY PACKS
DCB200, DCB204, DCB204BT, DCB205, DCB606
NOTE: Battery warranty voided if the battery pack is
tampered with in any way.
DeWALT
is not responsible
for any injury caused by tampering and may prosecute
warranty fraud to the fullest extent permitted bylaw.