Operation Manual

37
ENGLISH
You will hear and see the lock on switch return
downwards.
CAUTION: Before using the tool (each
time) be sure that the locking button
release mechanism is working freely. Be
sure to release the locking mechanism
before disconnecting the battery. Failure
to do so will cause the tool to start
immediately the next time the battery is
inserted. Damage or injury could result.
Screwdriving (fi g. 1, 4)
For best results, hold the screwdriver with your
hand directly in line with the fastener and press
the variable speed switch with the last one or two
fingers of the hand. This reduces the chance of
the screw slipping from the drive accessory when
pressure is applied.
To drive the fastener, place it on the bit, press the
variable speed switch and push the fastener into the
workpiece with a smooth, continuous motion. When
the fastener is seated, the clutch will disengage
automatically.
1. Install bit tip in bit holder.
2. Adjust depth locator (a).
3. Check for correct rotation, start screwdriver and
place screw on bit.
4. Contact work surface, applying forward
pressure to drive screw until depth locator
contacts the work surface. Screwgun will
ratchet automatically, disengaging bit from
screw.
5. This depth sensitive screwdriver is suitable for
driving drywall screws.
FOR THIS DEPTH SENSITIVE CLUTCH PLEASE REMEMBER:
• The bit will not turn until pressure is applied to
the unit. Push to engage.
• Trigger switch will not depress unless tool is in
either forward or reverse position.
SCREWDRIVING WITH COLLATED SCREWS (FIG. 5)
To drive collated screws the DCF6201 attachment
should be used. The magazine attachment allows
for faster work flow when driving multiple screws.
Instruction for installation, usage and cleaning of this
attachment is included in the attachment's supplied
manual.
Depth Adjustment
Follow the graphic on the collar to increase or
decrease the fastening depth. To seat the screw
deeper in the workpiece, turn the adjustment
collar to the right. To seat the screw higher in the
workpiece, turn the adjustment collar to the left.
Prior to Operation
1. Make sure your battery pack is (fully) charged.
2. Insert the appropriate drive accessory.
3. Select forward or reverse rotation.
4. Set the appropriate driving depth.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
Proper Hand Position (fi g. 4)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the rear
grip. Take care to not block the air vents (x).
Switching On and Off (fi g. 1)
1. To run the tool, press the variable speed switch
(g). The pressure exerted on the variable speed
switch determines the tool speed.
2. To stop the tool, release the variable speed
switch (g).
LOCK ON BUTTON
To lock the trigger switch (g) in the on position for
continuous operation, depress the trigger switch
and push up the lock on button(i). The tool will
continue to run. To turn the tool off, from a locked
on condition, squeeze and release the trigger once.