DCF899 DCF899H Final page size: A5 (148mm x 210mm)
English (original instructions) 3 Copyright DeWALT B
Fig. A 3 2 1 10 4 11 7 5 6 Fig.
Fig. C Fig. D 6 5 5 6 Fig. E 12 2 Fig.
English CORDLESS IMPACT WRENCH DCF899, DCF899H Congratulations! EC-Declaration of Conformity You have chosen a DeWALT tool. Years of experience, thorough product development and innovation make DeWALT one of the most reliable partners for professional power tool users. Machinery Directive Technical Data Voltage Type Battery type No load speed VDC min-1 Impact rate Max torque Weight (without battery pack) min-1 Nm kg DCF899, DCF899H 18 1 Li-Ion 0–400 0–1200 0–1900 0–2400 950 2.
*Date code 201811475B or later **Date code 201536 or later English Batteries Chargers/Charge Times (Minutes) Cat # VDC Ah DCB546 DCB547 DCB548 DCB181 DCB182 DCB183/B DCB184/B DCB185 DCB187 DCB189 18/54 18/54 18/54 18 18 18 18 18 18 18 6.0/2.0 9.0/3.0 12.0/4.0 1.5 4.0 2.0 5.0 1.3 3.0 4.0 Weight (kg) DCB104 1.05 1.46 1.44 0.35 0.61 0.40 0.62 0.35 0.54 0.
English contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns. e ) Do not use a battery pack or tool that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behaviour resulting in fire, explosion or risk of injury. f ) Do not expose a battery pack or tool to fire or excessive temperature. Exposure to fire or temperature above 130 °C may cause explosion.
English Chargers DeWALT chargers require no adjustment and are designed to be as easy as possible to operate. Electrical Safety The electric motor has been designed for one voltage only. Always check that the battery pack voltage corresponds to the voltage on the rating plate. Also make sure that the voltage of your charger corresponds to that of your mains. Your DeWALT charger is double insulated in accordance with EN60335; therefore no earth wire is required.
English 3. The completion of charge will be indicated by the red light remaining ON continuously. The battery pack is fully charged and may be used at this time or left in the charger. To remove the battery pack from the charger, push the battery release button 5 on the battery pack. NOTE: To ensure maximum performance and life of lithium-ion battery packs, charge the battery pack fully before first use. Charger Operation Refer to the indicators below for the charge status of the battery pack.
English WARNING: Never attempt to open the battery pack for any reason. If battery pack case is cracked or damaged, do not insert into charger. Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Electric shock or electrocution may result. Damaged battery packs should be returned to service centre for recycling. WARNING: Fire hazard.
English Do not expose to water. Have defective cords replaced immediately. Charge only between 4 ˚C and 40 ˚C. Only for indoor use. Discard the battery pack with due care for the environment. Charge DeWALT battery packs only with designated DeWALT chargers. Charging battery packs other than the designated DeWALT batteries with a DeWALT charger may make them burst or lead to other dangerous situations. Do not incinerate the battery pack. USE (without transport cap).
English To Install the Battery Pack into the Tool Handle 1. Align the battery pack 6 with the rails inside the tool’s handle (Fig. D). 2. Slide it into the handle until the battery pack is firmly seated in the tool and ensure that you hear the lock snap into place. To Remove the Battery Pack from the Tool 1. Press the release button 5 and firmly pull the battery pack out of the tool handle. 2. Insert battery pack into the charger as described in the charger section of this manual.
English Anvil With Hog Ring (Fig. B) DCF899H To install an accessory on the hog ring anvil, firmly push accessory onto the anvil 3 . The hog ring 9 compresses to allow the accessory to slide on. After accessory is installed, the hog ring applies pressure to help provide accessory retention. To remove an accessory, grasp the accessory and firmly pull it off. Usage Your impact tool can generate the following maximum torque: Cat # DCF899, DCF899H Nm 950 Ft.-Lbs. 700 In.-Lbs.
12
13
Belgique et Luxembourg België en Luxemburg DeWALT - Belgium BVBA Egide Walschaertsstraat 16 2800 Mechelen Tel: NL 32 15 47 37 63 Tel: FR 32 15 47 37 64 Fax: 32 15 47 37 99 www.dewalt.be enduser.BE@SBDinc.com Danmark DeWALT (Stanley Black&Decker AS) Roskildevej 22 2620 Albertslund Tel: Fax: 70 20 15 10 70 22 49 10 www.dewalt.dk kundeservice.dk@sbdinc.com Deutschland DeWALT Richard Klinger Str. 11 65510 Idstein Tel: Fax: 06126-21-0 06126-21-2770 www.dewalt.de infodwge@sbdinc.