Use and Care Manual

English

Mode Selector (Fig. 4)

CAUTION: Do not change to drill or hammerdrill mode with a chisel

bit in the chuck. Personal injury and damage to tool mayresult.

CAUTION: Never change the mode while the unit isrunning.

For straight drilling, rotate the mode

selector (D) until the arrow points to the drill

bit symbol (J). For rotary hammer mode,

align the arrow with the rotary hammer

symbol (K). For chipping mode, align arrow

with the chipping symbol (L).

NOTE: The mode selector (D) must be

in drill, hammer or chipping mode at all

times. There are no operable positions

inbetween.

Forward/Reverse Control Button (Fig. 2, 5)

A forward/reverse control button (C) determines the direction of bit

rotation and also serves as a lock-offbutton.

To select forward rotation, release the trigger switch (B) and depress

the forward/reverse control button on the right side of thetool.

To select reverse, depress the forward/reverse control button on the

left side of thetool.

The center position of the control button locks the tool in the

off position. When changing the position of the control button, be

sure the trigger isreleased.

NOTE: The first time the tool is run after changing the direction of

rotation, you may hear a click on start up. This is normal and does not

indicate aproblem.

FIG. 4

1. Position the utility hook into the extended position and remove the

hex headscrew.

2. Pull out the utility hook (J) until it is free fromunit.

3. Reinsert the utility hook into the desired side and push it into theslot.

NOTE: On some models the slot may be covered with a sticker.

Either remove the sticker or pierce the sticker to expose the

slotunderneath.

4. Re-insert the hex screw and tightensecurely.

If use of the hook is not desired at all, it can be removedcompletely.

FIG. 3