Use and Care Manual
ENGLISH
10
WARNING: Let the mower work at its own pace. Do
notoverload.
Adjusting Mower Height (Fig. I)
The height of cut is adjusted by the central cut height adjust
lever.
NOTE: If you are not sure which height to cut, begin
mowing with the cut height adjustment lever
10
positioned towards the rear of the appliance and adjust the
height down as needed, as shown in Fig.I.
To Set the Height of Cut
1. Pull the cut height adjustment lever
10
out of the
locking notch
17
.
2. Move the lever towards the rear of the appliance to raise
the height ofcut.
3. Move the lever towards the front of the appliance to
lower the height ofcut.
4. Push the height adjustment lever into one of the
lockingnotches.
Fig. I
10
17
Safety Key (Fig. J)
DANGER: Sharp moving blade. In order to prevent
accidental start-up or unauthorized use of your
Cordless Mower, a removable safety key
3
has been
incorporated into the design of your mower. The
mower will be completely disabled when the safety
key has been removed from themower.
NOTE: The safety key has a hole in the center to allow
for storage on a nail, out of the reach of children. do
not tether safety key tomower.
DANGER: Rotating blades can cause serious
injury. To prevent serious injury, remove safety
key and battery packs when unattended,
or when charging, cleaning, servicing,
transporting, lifting, or storingmower.
Fig. J
3
Starting Mower (Fig. K, L)
DANGER: Sharp moving blade. Never attempt
to override the operation of this switch box and
safety key system as serious injury couldresult.
NOTE: Mower is operational when batteries and safety key
areinstalled.
1. Insert safety key
3
into the ON-OFF switch box
1
until
it is fully seated inside housing as shown in Fig. K. The
mower is nowoperational.
2. Your mower is equipped with a special ON-OFF switch
box
1
. To operate the mower, push and hold the
ON-OFF button
2
on the ON-OFF switch box
1
, then
pull the bail handle
5
to the handlebar as shown
in Fig.L. Once the mower starts you can release
theON-OFF button.
3. To turn the mower OFF, release the bailhandle
5
.
WARNING: Never attempt to lock a switch or bail
handle in the ONposition.
NOTE: Once the bail handle has returned to the original
position it will activate the “Automatic Braking Mechanism”.
The motor is electrically braked and the mower blade will
stop rotating in three seconds orless.
Fig. K
3 1