Use and Care Manual

ENGLISH
12
Fig. J
8
4. Keeping fingers clear of the track, close the magazine by
releasing the pusher latch. Carefully allow the latch to
slide forward and engage the nailstrip.
Unloading the Tool

WARNING: The trigger lock-off should always be
locked off whenever any adjustments are made or
when tool is not inuse.
1. Slide the spring-loaded pusher latch to the base of the
magazine to lock it intoplace.
2. Tip the tool up until the fastener strip slides freely out of
themagazine.
3. With battery removed, check the nosepiece to verify
there are no nailsremaining.
Dry Fire Lock Out
The nailer is equipped with a dry fire lockout which prevents
the tool from actuating when the magazine in nearly empty.
When approximately 4 nails remain in the magazine, the
tool ceases to operate. Refer to Loading the Tool to reload a
stick of collatednails.
Adjusting Depth (Fig. K)
The depth that the nail is driven can be adjusted using the
depth adjustment wheel
3
on the nose of thetool.

WARNING: To reduce risk of serious injury from
accidental actuation when attempting to adjust
depth, ALWAYS:
• Remove batterypack.
• Engage trigger lock-off.
• Always point the nose of the nailer away
fromyou.
• Avoid contact with trigger duringadjustments.
1. To drive the nail shallower, rotate the depth adjustment
wheel
3
to the left, toward the shallow nailicon.
2. To drive a nail deeper, rotate the depth adjustment
wheel
3
to the right, toward the deeper nailicon.
Fig. K
3
Non-Mar Tip (Fig. L)
When using this tool on softer materials that you do not
want to mark, such as wood cladding, use the plastic non-
mar tip
15
over the contact trip
6
.
Fig. L
6
15
Jam/Stall Indicator Light (Fig. A)
There is a jam/stall indicator light
4
located on the foot of
thetool.
JAM/STALL CONDITION
Rotate the stall release
lever to release. Refer to
StallRelease.
Stall Release (Fig. M)
If the nailer is used in harder wood where all available
energy in the motor is used to drive a fastener, the tool
may stall. The driver blade will not complete the drive cycle
and the jam/stall indicator will flash. Rotate the stall release
lever
5
on the tool and the mechanism willrelease.
NOTE: The tool will disable itself and not reset until the
battery pack has been removed and reinserted. If the driver
blade does not automatically return to the home position,
proceed to Clearing a Jammed Nail. If the unit continues
to stall please review the material and fastener length to be
sure that it is not too rigorous anapplication.