Warranty

TROUBLESHOOTING GUIDE
MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW.
FOR MORE SERIOUS OR PERSISTENT PROBLEMS, CONTACT A D
e
WALT SERVICE CENTER OR CALL 1-(800)-4-D
e
WALT.
WARNING: To reduce the risk of serious personal injury, remove
fasteners from magazine before making any adjustments or servicing this tool.
SYMPTOM PROBLEMS SOLUTIONS
Air leak near top of tool or in trigger area Loose screws. Tighten screws.
Worn or damaged o-rings or seals. Install overhaul kit.
Tool does nothing or operates sluggishly Inadequate air supply. Verify adequate air supply.
Inadequate lubrication. Put 5 or 7 drops of oil into air inlet.
Worn or damaged valve. Install valve kit.
Air leak near bottom of tool Loose screws. Tighten screws.
Worn or damaged o-rings or bumper. Install Overhaul Kit.
Tool jams or skips frequently Incorrect fasteners. Verify approved fasteners of correct size and 15°
collation angle.
Fasteners loaded incorrectly Verify fasteners are loaded in the correct platform
position.
Damaged fasteners. Bent collation wire. Replace with undamaged fasteners.
Canister or nose screws loose Tighten screws.
Canister is dirty. Clean magazine.
Driver tip is worn or damaged. Install Driver Maintenance Kit.
Worn piston seal. Install overhaul kit.
Worn valve. Install valve kit.
Other Contact a D
e
WALT Authorized Warranty Service
Center
English
15