User Manual
30
ENGLISH
EC-Declaration of Conformity
Machinery Directive
Cable Stapler
DCN701
DeWALT
declares that these products described under
Technical Data are in compliance with:
2006/42/EC, EN60745-1:2009+A11:2010, EN60745-2-16:2010.
These products also comply with Directive 2014/30/EU and
2011/65/EU. For more information, please contact
DeWALT
at
the following address or refer to the back of themanual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of
DeWALT
.
Markus Rompel
Vice-President Engineering, PTE-Europa
DeWALT
, Richard-Klinger-Straße 11,
D-65510, Idstein, Germany
28.02.2019
WARNING: To reduce the risk of injury, read the
instructionmanual.
Definitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to
thesesymbols.
DANGER: Indicates an imminently hazardous
situation which, if not avoided, will result in death or
seriousinjury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or
seriousinjury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderateinjury.
NOTICE: Indicates a practice not related to
personal injury which, if not avoided, may result in
propertydamage.
Denotes risk of electricshock.
Denotes risk offire.
Congratulations!
You have chosen a
DeWALT
tool. Years of experience, thorough
product development and innovation make
DeWALT
one of the
most reliable partners for professional power toolusers.
Technical Data
DCN701
Voltage V
DC
18
Type 1
Battery type Li-Ion
Magazine angle 0°
Loading capacity 35
Staple lengths mm 25
Staple crown mm 19.7
Weight (without battery pack) kg 2.2
Noise values and vibration values (triax vector sum) according to EN60745-2-16:
L
PA
(emission sound pressure level) dB(A) 82
L
WA
(sound power level) dB(A) 93
K (uncertainty for the given sound level) dB(A) 3
Vibration emission value a
h
= m/s
2
3.9
Uncertainty K = m/s
2
1.5
The noise and vibration emission level given in this information
sheet has been measured in accordance with a standardised
test given in EN60745 and may be used to compare one tool
with another. It may be used for a preliminary assessment
ofexposure.
WARNING: The declared noise and vibration emission
level represents the main applications of the tool. However
if the tool is used for different applications, with different
accessories or poorly maintained, the noise and vibration
emission may differ. This may significantly increase the
exposure level over the total workingperiod.
An estimation of the level of exposure to noise and
vibration should also take into account the times when
the tool is switched off or when it is running but not
actually doing the job. This may significantly reduce the
exposure level over the total workingperiod.
Identify additional safety measures to protect the operator
from the effects of noise and vibration such as: maintain
the tool and the accessories, keep the hands warm,
organisation of workpatterns.
English (original instructions)
CABLE STAPLER
DCN701