User Guide

English
17
Troubleshooting Guide
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
TROUBLE! WHAT’S WRONG? WHAT TO DO
Saw will not start 1. Battery not installed 1. Install battery. Refer to Installing and Removing Battery Pack.
2. Battery not charged 2. Charge battery. Refer to Charging Procedure.
3. Brushes worn out 3. Have brushes replaced by authorized service center.
Saw makes unsatisfactory cuts 1. Dull blade 1. Replace blade. Refer to Changing or Installing a New Saw Blade.
2. Blade mounted backwards 2. Turn blade around. Refer to Changing or Installing a New Saw Blade.
3. Gum or pitch on blade 3. Remove blade and clean with coarse steel wool and turpentine or household oven cleaner.
4. Incorrect blade for work being
done
4. Change the blade type. Refer to Saw Blades under Optional Accessories.
XPS™ worklight is flashing 1. Battery not charged 1. Charge battery. Refer to Charging Procedure.
Machine vibrates excessively 1. Saw not mounted securely to
stand or work bench
1. Tighten all mounting hardware. Refer to Bench Mounting.
2. Stand or bench on uneven floor 2. Reposition on flat level surface. Refer to Familiarization.
3. Damaged saw blade 3. Replace blade. Refer to Changing or Installing a New Saw Blade.
Does not make accurate miter
cuts
1. Miter scale not adjusted correctly 1. Check and adjust. Refer to Miter Scale Adjustment under Adjustments.
2. Blade is not square to fence 2. Check and adjust. Refer to Miter Scale Adjustment under Adjustments.
3. Blade is not perpendicular to
table
3. Check and adjust fence. Refer to Bevel Square to Table Adjustment under Adjustments.
4. Workpiece moving 4. Clamp workpiece securely to fence or glue 120 grit sandpaper to fence with rubber cement.
5. Kerf plate worn or damaged 5. Take to authorized service center.
Material pinches blade 1. Cutting bowed material 1. Refer to Bowed Material under Special Cuts.