operation manual
25
ENGLISH
EC-Declaration of Conformity
Machinery Directive
Reciprocating Saw
DCS367
DeWALT
declares that these products described under Technical
Data are in compliance with:
2006/42/EC, EN62841-1:2014, EN62841-2-11:2016.
These products also comply with Directive 2014/30/EU and
2011/65/EU. For more information, please contact
DeWALT
at
the following address or refer to the back of themanual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of
DeWALT
.
Markus Rompel
Vice President of Engineering, PTE-Europe
DeWALT
, Richard-Klinger-Straße 11,
D-65510, Idstein, Germany
28.09.2019
WARNING: To reduce the risk of injury, read the
instruction manual.
Definitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to
thesesymbols.
DANGER: Indicates an imminently hazardous
situation which, if not avoided, will result in death or
seriousinjury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or
seriousinjury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderateinjury.
NOTICE: Indicates a practice not related to
personal injury which, if not avoided, may result in
propertydamage.
Denotes risk of electricshock.
Denotes risk offire.
Congratulations!
You have chosen a
DeWALT
tool. Years of experience, thorough
product development and innovation make
DeWALT
one of the
most reliable partners for professional power toolusers.
Technical Data
DCS367
Voltage V
DC
18
Type 1/10
Battery type Li-Ion
Max. power output W 824
No-load speed min
-1
0–2900
Stroke length mm 28.6
Weight (without battery pack) kg 2.27
Noise values and/or vibration values (triax vector sum) according to
EN62841-2-11:
L
PA
(emission sound pressure level) dB(A) 88
L
WA
(sound power level) dB(A) 99
K (uncertainty for the given sound level) dB(A) 3
While cutting board
Vibration emission value ah,
B
= m/s
2
17.5
Uncertainty K = m/s
2
5.7
While cutting wooden beam
Vibration emission value a
h,WB
= m/s
2
22.0
Uncertainty K = m/s
2
3.1
The vibration and/or noise emission level given in this
information sheet has been measured in accordance with
a standardised test given in EN62841 and may be used to
compare one tool with another. It may be used for a preliminary
assessment ofexposure.
WARNING: The declared vibration and/or noise emission
level represents the main applications of the tool. However
if the tool is used for different applications, with different
accessories or poorly maintained, the vibration and/or
noise emission may differ. This may significantly increase
the exposure level over the total workingperiod.
An estimation of the level of exposure to vibration and/
or noise should also take into account the times when the
tool is switched off or when it is running but not actually
doing the job. This may significantly reduce the exposure
level over the total workingperiod.
Identify additional safety measures to protect the
operator from the effects of vibration and/or noise such
as: maintain the tool and the accessories, keep the
hands warm (relevant for vibration), organisation of
workpatterns.
English (original instructions)
CORDLESS RECIPROCATING SAWS
DCS367