Use and Care Manual
ENGLISH
10
Installing Abrasive and Diamond Wheels
(Fig. A, D)
WARNING: Install only oneblade.
1. Lay unit on a firm surface, with the arbor screw
11
facingupward.
2. Using supplied 1/2" (13mm) open end wrench
6
(located in the battery compartment), remove arbor
screw
11
, outer clamp washer
20
and used wheel
21
if one is installed. Hold arbor screw
11
from turning
with spindle lock button
13
. Spindle threads are
righthand.
3. The inner clamp washer
22
is held in place with a
double D shaft and retainingring.
4. Slip wheel over spindle
24
. Slip on outer clamp washer.
Start threading on arbor screw which will self align outer
clampwasher.
IMPORTANT: Make sure the diamond blade is installed
with the correct rotation, as marked on the blade
rotation indicator
12
.
5. Engage spindle lock button and tighten screw firmly
with wrench. Do not over-tighten arborscrew.
6. Turn wheel by hand to ensure it is properly centered.
The wheel should not hit the shoe or guard. The screw
and flanges should betight.
CAUTION: Only use 9" (230mm) Type 1/41 wheels
with 7/8" (22.2mm) arbor hole with this tool. Never
force a wheel onto the machine or alter the size of the
arborhole.
11
20
21
22
Fig. D
24
12
Replacing Worn Clamp Washers (Fig. D)
WARNING: Replace clamp washers as they wear.
They may become sharp with extendeduse.
1. Remove the arbor screw
11
, outer clamp washer
20
and used wheel
21
if one is installed as described in
Installing Abrasive and DiamondWheels.
2. To remove the inner clamp washer
22
, first remove the
retainingring that holds the inner clamp washer to the
double Dshaft.
3. Remove the inner clamp washer and replace with a new
one. Orient the inner clamp washer with the depressed
center section toward the blade. Make sure the new
inner clamp washer is secure with the retaining ring
inplace.
4. Install the wheel
21
, new outer clamp washer
20
, and
arbor screw
11
as described in Installing Abrasive and
DiamondWheels.
Adjusting the Guard Angle (Fig. E)
WARNING: Do not use guard rotation handle to
hold tool while cutting. Guard rotation handle is
only used for adjustment of the guard while tool is
not inuse.
CAUTION: Guard may be hot. Use guard handle to
rotateguard.
WARNING: Always make sure the guard is properly
engaged before starting themachine.
You can adjust the angle of theguard.
1. To adjust the angle of the guard, pull back the guard
rotation release lever
14
and holdit.
2. Grasp the guard
2
firmly by guard rotation handle
10
and rotate to desiredangle.
3. Release the guard rotation release lever and make sure
it engages, locking the guard in place. If the guard
rotation release lever doesn't engage, rotate the guard
slightly until the guard rotation release lever returns to
the lockedposition.
2
Fig. E
14
10
DeWALT
Tool Tag Ready (Fig. F)
Optional Accessory
Your cut-off saw comes with mounting holes
15
and
fasteners for installing a
DeWALT
Tool Tag. You will need
a T15 bit tip to install the tag. The
DeWALT
Tool Tag is
designed for tracking and locating professional power
tools, equipment, and machines using the
DeWALT
Tool
Connect™ app. For proper installation of the
DeWALT
Tool
Tag refer to the
DeWALT
Tool Tagmanual.