Use and Care Manual

14
English

 
Unit will not start.  • Checkbatteryinstallation.
 • Checkbatterychargingrequirements.
 • Checkthatlockoffisfullypulledbackpriortomovingmaintrigger.
Unit shuts down in use.  • Chargebattery.
 • Cleardebrisaroundspool.
 • Reduce/limitswathto13inches(330mm)MAX.
 • Reinstallguardifithasbeenremoved.
Battery won’t charge.  • Insertbatteryintochargeruntilredcharginglightilluminates.Chargeupto8hoursifbatteryis
totally drained.
 •
Plug charger into a working outlet. Refer to Important Charging Notes for more details.
• Checkcurrentatreceptaclebyplugginganappliance.
 • Checktoseeifreceptacleisconnectedtoalightswitchwhichturnspoweroffwhenyouturn
out the lights.
 • Movechargerandappliancetoasurroundingairtemperatureofabove40°F (4.5°C) or below
105°F (40.5°C).
Appliance runs slowly.  • Fullydepressthevariablespeedtrigger.Theleveloftriggerdepressionaffectsspeed.
 • If appliance still runs slowly, remove battery from appliance.
 • Checkthatthespoolhousingcanrotatefreely.Carefullycleanitifnecessary.
 • Checkthatthecuttinglinedoesnotprotrudemorethanapproximately4-13/16" (122 MM) from
the spool. If it does, cut it off so that it just reaches the line trimming blade.
Trimmer is vibrating. • Makesurebothcuttinglinesarethesamelength.
 • Checktoseeifthespoolisproperlywound.Ifspoolisbrokenthenreplacespool.