Use and Care Manual

13
English
Accessories
WARNING: Since accessories, other than those
offered by D
eWALT, have not been tested with this product, use of
such accessories with this appliance could be hazardous. To reduce
the risk of injury, only D
eWALT recommended accessories should be
used with this product.
Recommended accessories for use with your appliance are available
at extra cost from your local service center. If you need any assistance
in locating any accessory, please contact D
eWALT Industrial Tool Co.,
701 East Joppa Road, Towson, MD 21286, call 1-800-4-D
eWALT
(1-800-433-9258) or visit our website: www.dewalt.com.
Repairs
The charger and battery pack are not serviceable. There are no
serviceable parts inside the charger or battery pack.
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments (including brush inspection and replacement) should
be performed by a D
eWALT factory service center, a DeWALT
authorized service center or other qualified service personnel. Always
use identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
• WARRANTY SERVICE: Registering your product will help you
obtain more efficient warranty service in case there is a problem
with your product.
• CONFIRMATION OF OWNERSHIP: In case of an insurance
loss, such as fire, flood or theft, your registration of ownership will
serve as your proof of purchase.
• FOR YOUR SAFETY: Registering your product will allow us to
contact you in the unlikely event a safety notification is required
under the Federal Consumer Safety Act.
Register online at www.dewalt.com/register.
Replacing Guard (Fig. 19–20)
WARNING: Never operate appliance without guard
firmly in place.
1. Remove the spool housing as described in the "Replacing Spool
Housing" section.
2. Remove the 4 guard screws (19A) shown in Figure 19.
3. Lift the guard off at an angle as shown in Figure 20.
19A
19A
FIG. 19
FIG. 20
FIG. 21
21A
21B
4. To attached a new guard, slide the
tab (21A) of the new guard under the
lip (21B) of the motor housing (E),
then lower the back of the guard into
place as shown in Figure 18.
5. Replace and securely tighten the 4
guard screws (19A).
6. Replace the spool housing as
described in the "Replacing Spool
Housing" section.