Use and Care Manual

ENGLISH
10
12. Line up the white nubs
22
inside the spool housing
with the recesses
28
of the spool. Align the holding
slots
24
with the two holes
27
as close as possible.
13. Push the spool into the spool housing and turn
counterclockwise to lock the spool in place. Ensure the
white nub
22
appears in the spool window
21
. Make
sure the line doesn't unravel and wrap around the shaft
below the spool.
14. Pull both ends of the cutting line to release them from
the holding slots. If the line extends past the cutting blade
on the guard cut the line so it just reaches the blade.
fig. M
27
22
28
Replacing Spool Housing (Fig. N, O)
1. Rotate the spool housing
11
until the hole
29
in the
spindle
30
lines up with notch
31
in the guard
10
.
A third hole in the motor housing
32
will be visible as
shown in figureN. Insert screwdriver through each all
three holes to prevent the spool housing from turning.
2. Turn the spool housing clockwise as shown in figureO.
3. Insert a screwdriver back through the three holes
(
29
,
31
, and
32
) and thread the new spool housing
counterclockwise and securely tighten onto the bolt
33
protruding from the trimmer.
fig. N
30
29
32
31
fig. O
33
Replacing Guard (Fig. P, Q)

WARNING: Never operate appliance without guard
firmly in place. Damage or personal injury could result.
1. Remove the spool housing as described in the
"Replacing Spool Housing" section.
2. Remove the 4 guard screws
34
shown in figureP.
3. Lift the guard off at an angle as shown in figureQ.
fig. P
34
34
fig. Q
4. To attached a new guard, slide the tab
35
of the new
guard under the lip
36
of the motor housing
6
, then
lower the back of the guard into place as shown in
figureR.
5. Replace and securely tighten the 4 guard screws
34
.
6. Replace the spool housing as described in the
"Replacing Spool Housing" section.
fig. R
36
35
Repairs
The charger and battery pack are notserviceable.

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a
DeWALT factory service center
or a DeWALT authorized service center. Always use
identical replacementparts.
Register Online
Thank you for your purchase. Register your product nowfor:
• WARRANTY SERVICE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with yourproduct.
• CONFIRMATION OF OWNERSHIP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
ofpurchase.
• FOR YOUR SAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
SafetyAct.