User Manual

ENGLISH
10
Fig. F2
24
Using Template Guides
The round subbase will accept universal template guides.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
servicecenter.
NOTE: The D-shape subbase does not accommodate
template guides and is designed to accommodate bits up
to 1-3/8" (34.9mm) indiameter.
To Use Template Guides:
1. Center the subbase. See Centering TheSubbase.
2. Install template guide (available as an accessory) on the
subbase and tightensecurely.
Installing a Fixed Base Edge Guide (Fig. G)
(Included with some models)
An edge guide (model DNP618) for your fixed base is
available from your local retailer or service center at
extracost.
1. Remove the motor from the fixed base. Refer to
Removing the Motor from the FixedBase.
2. Remove flat head screws
26
from storage holes on
edgeguide.
3. Slide edge guide
25
into edge guide slot
27
on side
of fixed base (Fig.G). Insert the two flat head screws
through the appropriate holes in the subbase to secure
the edge guide. Tightenhardware.
4. Follow all instructions included with the edgeguide.
NOTE: To remove the edge guide, reverse the above
procedure. After removing edge guide, always replace the
two flat head screws into the storage holes on the edge
guide to preventloss.
26
25
27
Fig. G
Using a Premium Edge Guide
(Plunge Base Only)
(Included with some models)
A Premium Edge Guide (model DW6913) is available from
your local retailer or service center at extra cost. Follow the
assembly instructions included with the edgeguide.
Installing a Plunge Base Edge Guide with
Guide Rods (Fig. H)
(Included with some models)
An edge guide (model DW6913) for your plunge base
is available from your local retailer or service center at
extracost.
1. Attach the guide rods
35
to the plunge routerbase.
2. Attach the thumb screws
36
and springs
37
to
thebase.
3. Tighten the thumb screws
36
.
4. Slide the edge guide
38
over therods.
5. Attach thumb screws
36
and springs
37
to the
edgeguide.
6. Tighten the thumb screws temporarily. Refer to
Adjusting the EdgeGuide.
Adjusting the Edge Guide (Fig. A, H)
Follow the assembly instructions included with the
edgeguide.
1. Draw a cutting line on thematerial.
2. Lower the router carriage until the cutter is in contact
with theworkpiece.
3. Lock the plunge mechanism by releasing the plunge
lock lever
16
4. Position the router on the cutting line. The outer cutting
edge of the cutter must coincide with the cuttingline.
5. Slide the edge guide
38
against the workpiece and
tighten the thumb screws
36
.