Use and Care Manual

ENGLISH

Assembling the Sprayer

1. Install the wand (C) onto the shut-o assembly

(B) and tighten the nut (1) on the wand (C) to

secure together.

Fig. 4

Attaching a Nozzle

Attach your selected nozzle (J – O) onto the end of the

wand (C) using a at seal (E) if required, and tighten

securely using the cap nut (D).

Fig. 5

C E

Harness Installation

1. For each side of the harness (G), remove the

small plastic clips (1) from the two shoulder strap

loops and thread each loop through the slots at

the top of the sprayer handle.

2. Replace the clips (1) through the loops and pull

the strap securing the two harness (G) straps in

place.

Fig. 6

3. Insert the strap into the “back” cutout of the

lower base below the steel harness rod. Pull

excess length through to allow for step 2.

4. Loop excess strap below and back through the

“bottom” cutout. Be sure that the strap loops

around below the harness rod.

5. As the strap is pushed, it will follow the curved

surface of the plastic lower base, and come back

outward from the “back” cutout.

6. Pull excess material through to loop back

through rst section of buckle.

NOTE: If the strap comes right out of the lower base

when pulling through the buckle (or prior), this shows

that the strap was not properly looped around the

harness rod, and steps 3-6 will need to be repeated.

7. Loop through second portion of buckle above

lower strap section, and adjust accordingly.

8. Harness in assembled position as shown in Fig 7.

Fig. 7

9. Loop the strap through the rst section of

the buckle (2). Then loop the strap through

the other section of the buckle (2) to tighten.

Adjust the shoulder pads and strap lengths for a

comfortable t.

Fig. 8