INSTRUCTION MANUAL DE0892-XE LASER DETECTOR
WARNING! Read all safety warnings and all instructions Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
• • • • • Remove dead batteries immediately and dispose of per local codes. Do not dispose of batteries in fire. Keep batteries out of reach of children. Remove batteries if the device will not be used for several months. Young children and the infirm. This appliance is not intended for use by young children or infirm persons without supervision.
ASSEMBLY AND ADJUSTMENTS OPERATION Instructions for Use WARNING: Refer to the manual of the tool to be used with this attachment. Batteries (Fig. 1) WARNING: • Always observe the safety instructions and applicable regulations. • Before first use, remove and discard the protective tape from the screens. The digital laser detector is powered by a 9-volt battery. To install the battery provided, lift up on the battery compartment cover (C).
Mounting on a Grade Rod (Fig. 1, 2) MAINTENANCE Your attachment has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning. 1. To secure your detector to a grade rod, first attach the detector to the clamp by pushing in on the clamp latch (J). Slide the tracks (K) on the clamp around the rail (L) on the detector until the latch (M) on the clamp pops into the latch hole (N) on the detector. 2.
THE DETECTOR DOES NOT RESPOND TO THE BEAM FROM ANOTHER LASER UNIT • The DEWALT Digital Laser Detector has been designed to work only with the DW088 and the DW089 and certain other compatible line lasers. THE DETECTOR GIVES OFF A TONE BUT THE LCD DISPLAY WINDOW DOES NOT FUNCTION • If the detector is very cold, allow it to warm up in a heated area. • If the LCD display window is still not functioning, take the detector to a DEWALT service centre.
Stanley Black & Decker 82 Taryn Drive, Epping, VIC 3076 Australia • 1800 444 224 (Aust) or 0800 339 258 (NZ) www.dewalt.com.au • www.dewalt.co.nz (FEB12) Part No. N163481 DE0892-XE Copyright © 2012 DEWALT The following are trademarks for one or more DEWALT power tools: the yellow and black color scheme; the “D” shaped air intake grill; the array of pyramids on the handgrip; the kit box configuration; and the array of lozenge-shaped humps on the surface of the tool.
