Specifications

29


WARNING: Risk of unsafe operation. Always wear gloves and c ertified safety equipment:
ANSI Z87.1 eye protection (CAN/CSA Z94.3) with side shields when assembling and
disassembling.
 1.Slide the starter rope (G1) through
G1
N1
A1
the starter reel (A1) and tie a knot
(N1)intheropeasshown.Windthe
starter rope around the starter reel
in the direction of the arrow.
NOTE: Leave approximately 12"
(30cm) of starter rope outside the
starter reel.
 2.Placethehook(P1)ontheouterside
O1
P1
A1
ZZ
of the spring (ZZ) into the groove
(O1)insidethestarterreel(A1).
3. Place the starter reel on the recoil
coversothespringinnerhookhooks
to the case tab.
4. While holding the recoil cover, rotate
the starter reel two revolutions in the
direction of the arrows for prelimi-
nary winding.
5. Slide the starter rope end through
Q1
the recoil cover rope guide and pull
it outwards. Pass the starter rope
throughthestartergrip(Q1)andtie
aknotintheropeasshown.NOTE:
Rope will be under tension, clamp
rope with vise or similar devise to
hold rope while tying.
WARNING: Risk of unsafe operation.
Do not separate the starter reel from the
recoil cover. If they are separated the
return spring inside the case will come off
and could cause serious injury.
 6.Install the ratchets (E1) with the
D1
F1
C1
M1
E1
frictionsprings(C1),snapring(M1)
and reel cover (D1). Tighten reel
coverbolt(F1).
7. Pull the starter rope several times to
check the operation of the ratchet.
NOTE: Ratchet should extend
outward while pulling starter rope
and then retract.