www. .
5 3 6 7 8 9 4 10 1 2 12 11 A1 18 13 14 15 16 17 A2 1
19 21 20 B1 A3 22 23 21 B3 B2 7 26 25 24 D C 28 29 30 33 6 5 27 31 2 0 E 45 32 F1
35 38 39 34 9 12 F2 G1 37 36 41 43 42 36 G2 37 19 40 48 H 15 I J 45 44 46 47 K L 3
ENGLISH TABLE SAW DW745 Congratulations! You have chosen a DEWALT tool. Years of experience, thorough product development and innovation make DEWALT one of the most reliable partners for professional power tool users. Technical Data Voltage DW745-QS DW745-LX V 230 115 3 3 W 1700 1300 Type Motor power (input) Motor power (output) W 1100 936 No-load speed min-1 3800 3800 Blade diameter mm 250 250 Blade bore mm 30 30 Blade body thickness mm 2.3 2.
ENGLISH 9 Secure workpiece Use clamps or a vice to hold the workpiece. It is safer and it frees both hands to operate the tool. 10 Connect dust extraction equipment If devices are provided for the connection of dust extraction and collection facilities, ensure that these are connected and properly used. 11 Remove adjusting keys and wrenches Always check that adjusting keys and wrenches are removed from the tool before operating the tool.
ENGLISH - Health hazards caused by breathing dust developed when sawing wood, especially oak, beech and MDF.
ENGLISH • Connect the brown lead to the live terminal in the plug. • Connect the blue lead to the neutral terminal. WARNING: No connection is to be made to the earth terminal. Follow the fitting instructions supplied with good quality plugs. Recommended fuse: 13 A. FITTING A MAINS PLUG TO 115 V UNITS The plug should be fitted by a competent person. If you are in doubt, contact an authorized DEWalt repair agent or qualifued electrician.
ENGLISH Mounting and adjusting the parallel fence (fig. A1, F1 & F2) The rip fence (8) can be installed on the left or right side of your table saw. • Locate the screw (31) with the slot (32) in the rip fence. • Secure the rip fence by snapping both latches (33) in place. Adjusting the fence parallel to the blade The fence has been factory-set. If you need to re-adjust, proceed as follows: • Set the saw blade to its highest position. • Remove the upper blade guard (6). • Set the bevel angle to 0°.
ENGLISH • After completing the cut, switch the machine off, allow the blade to stop and remove the workpiece. WARNING: • Never push or hold the "free" or cut-off-side of the workpiece. • Do not cut excessively small workpieces. • Always use a push stick when ripping small workpieces. Bevel cuts • Set the required bevel angle. • Proceed as for ripping. Cross-cutting (fig. J) • Remove the rip fence and install the mitre fence in the desired slot. • Lock the mitre fence at 0°. • Set the bevel angle to 0°.
ENGLISH Keep the ventilation slots clear and regularly clean the housing with a soft cloth. Regularly clean the dust collection system (fig. L): • Turn the saw on its side. • Remove the screws (46) (fig. L). • Remove all dust and resecure the access door (47) using the screws (fig. L). Protecting the environment Separate collection. This product must not be disposed of with normal household waste.
