Extra Information

8
Storage (Fig. 11)
1. Empty the canister, refer to To Empty
J
S
FIG. 11
Canister under Operation.
2. Clean the vacuum inside and
outside. Refer to Cleaning.
3. Clean or replace filters,
refer to Filters.
4. Store the suction hose and the
power cord as shown in figure 11.
Place the unit in a dry room and
secure it from unauthorized use.
NOTE: Plug inlet plug (S) into inlet
(J) to keep debris inside canister
when suction hose is removed. You
can also attach the ends of the hose
together and lock together with the
twist-lock end.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
Accessories
WARNING: Since accessories, other than those offered by DEWALT, have not
been tested with this product, use of such accessories with this appliance could be
hazardous. To reduce the risk of injury, only DEWALT recommended accessories
should be used with this product.
Recommended accessories for use with your appliance are available at extra cost
from your local service center. If you need any assistance in locating any accessory,
please contact Stanley Black & Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or
call 1800 444 224 or (NZ) 0800 339 258.
5. Inspect filters for wear, tears or other damage.
NOTE: If there is any doubt on the condition of the filters they MUST be replaced.
DO NOT continue use if filters are damaged.
6. If no damage to filters: Wash filters in low pressure, room temperature water
and allowed to dry. Filters may be reinstalled after they are completely dry, refer
to To Install Filters.
To Install Filters
1. Ensure filter seal (Z) is in place and is secure
Z
FIG. 10
Y
2. Line up filter threads (Y) to vacuum head threads and using moderate force, turn
filter clockwise until tight.
NOTE: Use care to not damage filter material.
3. Place the vacuum head (C) onto the container and secure it by closing the
canister latches (D).
Lubrication
Your power appliance requires no additional lubrication.
Cleaning
WARNING: Never use solvents or other harsh chemicals for cleaning the non-
metallic parts of the appliance. These chemicals may weaken the materials used in
these parts. Never let any liquid get inside the machine; never immerse any part of the
appliance into a liquid.
1. Vacuum the outside of the dust extractor. For further cleaning use a cloth
dampened only with water and mild soap if necessary.
2. After use dispose of cloth in an appropriate container.