Instructions / Assembly

English

3. When “0” is reached, a beep will sound and the LCD Screen will

show the following:

The Pump Engine Icon will light solid and the Digital Display

shows “0 SEC” to indicate the vehicle is ready to start. The

Clamps Icon and the Battery Icon light solid. The bars on the

Battery Icon will change from empty to solid (bottom to top)

repeatedly.

4. Crank the engine using manufacturer’s guidelines, typically in 3 to

5 second bursts. The Digital Display shows “5 SEC” (a 5-second

countdown to use as a timer when cranking the engine).

5. After cranking, the unit will automatically adjust the charging current

to 7.5A for 5 minutes, and then revert to Charging Mode. To stop

charging, press the Battery Charge Button.

IMPORTANT: The Engine Start function requires a resting/cooling

period between attempts. Wait 4 to 5 minutes before a second

attempt at starting the engine, if needed.

6. When disconnecting the battery charger, unplug the AC Power

Cord, and then disconnect the battery charger from the battery

following the last step of the appropriate set of directions in the

“Preparing to Charge” section of this Instruction Manual.

USB Port

The USB Power Button and the USB Port are located on the front of

unit. The USB Power/Fault Indicator is a translucent ring around the

USB Port. Refer to Fig. 2 to locate.

Important Notes Concerning the USB Port

1. This unit’s USB Port does not support data communication. It only

provides power to an external USB-powered device. The USB Port

provides up to 3.1A (5V).

2. When the USB Port is in use, the unit will monitor for the following

USB fault conditions: thermal fault, overload and short circuit. If a

fault condition exists the USB Power/Fault Indicator will flash blue.

In any of these cases, the LCD screen will continuously display the

following:

The USB Icon and the Fault Icon will flash. The USB Port will

automatically shut down. Should this occur:

a. Disconnect the USB-powered device and press the USB Power

Button again to turn off the USB Port immediately.

b. Allow the unit to cool down for several minutes before attempting

to use the USB Ports again.

c. If a fault occurs again, make sure that the draw of the USB device

plugged into the USB Port does not exceed 3.1A.

d. If an individual USB device is within specifications and the fault

occurs, have the USB device checked for malfunction and do

not continue to use it with this USB Port.

DXAEC210_ManualENFRSP_092116.indd 22 10/19/2016 3:58:55 PM