Full Product Manual

ManualsBrandsDEWALT ManualsAutomotive1600 Peak Amp Lithium Jump Starter with USB Power Bank

English

Except for the fuse in the 12V DC/USB Charging Adapter, there

are no user-replaceable parts. Periodically inspect the condition of

adapters, connectors and wires. Contact manufacturer to replace any

components that have become worn or broken.

THE INTERNAL BATTERY

All batteries lose energy from self-discharge over time and more rapidly

at higher temperatures. When the unit is not in use, we recommend

that the battery is charged at least every 3-6 months.

BATTERY REPLACEMENT

The battery should last the service life of the unit. Service life is

dependent on a number of factors including but not limited to the

number of recharge cycles, and proper care and maintenance of the

battery by the end user. Contact manufacturer for any information you

may need.

SAFE BATTERY DISPOSAL

Contains a lithium battery, which must be disposed of

properly. Recycling is required. Failure to comply with

local, state and federal regulations can result in fines, or

imprisonment.

Please recycle.

WARNING – To reduce the risk of serious injury or property

damage:

• Do not dispose of the battery in fire as this may result in an explosion.

• Before disposing of the battery, protect exposed terminals with

heavy-duty electrical tape to prevent shorting (shorting can result

in injury or fire).

• Do not expose battery to fire or intense heat as it may explode.

12 VOLT DC/USB ADAPTER PLUG FUSE REPLACEMENT

(OPTIONAL ACCESSORY)

The fuse in the plug end of the 12 Volt DC/USB Adapter protects the

adapter’s charging circuit. If the built-in 120 Volt AC Charger operates,

but the DC charging adapter does not, then this fuse may be opened

(blown).

To replace the fuse:

1. Unscrew the end cap of the DC plug (counterclockwise).

2. Remove spring center contact and fuse.

END CAP

CENTER

CONTACT

2A FUSE

3. Check fuse with a continuity checker.

4. If blown, locate a replacement 2 amp.

5. Replace the fuse, spring, contact and end cap.

6. Screw end cap clockwise until it is finger tight –

DO NOT OVER-TIGHTEN.

7. Test for proper operation of the 12 volt DC

charging adapter.