Instructions / Assembly

English
19
INFLATING TIRES OR PRODUCTS WITH VALVE STEMS
1. Screw the SureFit
®
nozzle onto the valve stem. Do not overtighten.
2. Press the Compressor Power Button. A beep will sound and the
backlit LCD screen will display the following:
The Compressor Icon will light and the digital display will alternately
show the flashing pre-set psi value (that was last set by the
compressor pressure control buttons) and the current pressure of
the item being inflated (which will light solid).
3. Press the “ ” and “ ” Pressure Control Buttons to set the desired
pressure from a range pre-set values (between 3 and 120), which
will display on the backlit LCD screen. The unit will sound a beep
with each press of the buttons (holding the button speeds up the
upward or downward value selection). Once the desired pressure
has been entered, release the button and the flashing digital display
will show the new selected pressure, as follows:
The new selected value is now stored in the unit’s memory until it
is manually reset.
4. Press the Compressor Power Button once more to begin inflating.
The Compressor Icon will flash and the digital display will only show
the current pressure value (which will light solid) to indicate the
compressor is activated. Monitor the pressure on the LCD screen.
IMPORTANT NOTE: To interrupt during inflation, press the
Compressor Power Button again.
5. When desired pre-set pressure is reached, the compressor will
automatically stop.
6. Press the Compressor Power Button again to turn off the unit.
7. Unscrew and remove the SureFit
®
nozzle from the valve stem.
8. Allow the unit to cool, then recharge before storing away.
9. Store the compressor hose and SureFit
®
nozzle in storage
compartment.
INFLATING OTHER INFLATABLES WITHOUT VALVE STEMS
Inflation of other items requires use of the nozzle adapter.
1. Screw the nozzle adapter into the SureFit
®
nozzle. Do not
overtighten.
2. Insert the nozzle adapter into item to be inflated.
3. Follow steps 2 through 4 of the “Inflating Tires or Products With
Valve Stems” section.
IMPORTANT: Small items such as volleyballs, footballs, etc. inflate
very rapidly. Keep this in mind when setting pressure. Take extra
care not to over-inflate.
4. When the desired pressure is reached, the compressor will
automatically stop. Press the Compressor Power Button again to
turn off the unit.
5. Disconnect the adapter from the inflated item.
6. Unscrew and remove the nozzle adapter from the SureFit
®
nozzle.
7. Allow the unit to cool, then recharge before storing away.
8. Store the compressor hose, SureFit
®
nozzle and nozzle adapter
in the storage compartment.
DXAEPS2_ManualENSP_101216.indd 19 10/19/2016 3:56:34 PM