Instructions / Assembly

English

1. Press the AC Power Button to turn on both 120V AC Power

Outlets. A beep will sound and the LCD Screen will display the

following:

The Battery Status Icon and the Wattage Indicator light solid; and

the Digital Display shows “0,” indicating the dual AC outlets are

ready to use.

2. Insert the 120 volt AC plug from the appliance into one of the 120

volt AC outlets.

3. Switch on the appliance and operate as usual. The LCD Screen

will continuously display the following:

The Battery Status Icon and the Wattage Indicator light solid; and

the Digital Display shows the total output wattage of the dual AC

outlets.

NOTE: Ensure that the wattage of all equipment simultaneously

plugged into both 120V AC Power Outlets does not exceed 1000

watts continuous.

4. Press the AC Power Button again to turn off the 120V AC Power

Outlets.

Monitor the unit’s internal battery status on the LCD Screen. Four solid

bars in the battery icon indicates a full battery. When the battery level

is nearly empty with only one solid bar, the unit MUST be recharged

at this time.

Make sure the AC Power Outlets are turned off when the unit is being

recharged or stored.

USB Ports

The USB Power Button and the two USB Ports are located on the front

of the unit; the USB Power/Fault Indicator is a translucent ring around

each of the USB Ports. Refer to Fig. 2 to locate.

Important Notes Concerning the USB Ports

1. The two USB Ports provide a total of 3.1A (5V each).

2. When the USB Ports are in use, the unit will monitor for the following

USB fault conditions on all the USB Ports: thermal fault, low battery

voltage fault, overload and short circuit. If a fault condition exists in

either of the USB Ports, the USB Power/Fault Indicators will flash

blue. In any of these cases, the backlit LCD screen will continuously

display the following:

The Fault Icon will flash. The USB Ports will automatically shut

down. Should this occur:

a. Disconnect the USB-powered device and press the USB Power

Button again to turn off the USB Ports immediately.

b. Make sure the unit does not need to be recharged.

DXAEPS2_ManualENSP_101216.indd 21 10/19/2016 3:56:35 PM