Instructions / Assembly
English
25
Problem Possible Solution
120 Volt AC Outlet will
not power appliance
Make sure the AC Power Button has
been turned on.
Make sure you have followed all the
steps in the “120 AC Power Outlets”
section carefully. Refer to the important
notes included in that section that
explain common problems and
solutions.
Make sure the combined draw of all
appliances being powered is not more
than 1000 watts.
Check that unit has a full charge.
Recharge unit if necessary.
USB Port will not
power device
Make sure the USB Power Button is in
the on position.
Make sure all the USB Power/Fault
Indicators light solid blue. If a fault
condition exists in either of the USB
Ports, the USB Power/Fault Indicators
will flash blue. Refer to the Important
Notes in the “USB Ports” section to
remedy any faults.
Make sure that the total draw of all USB
devices plugged into the USB Ports
does not exceed 3.1A.
Problem Possible Solution
USB Port will not
power device
(continued)
Some USB-powered household
electronics will not operate with this
USB charging/power port. Check the
manual of the corresponding electronic
device to confirm that it can be used
with this type of USB charging/power
port.
Check that the unit has a full charge.
Recharge the unit if necessary.
LED Area Light does
not come on
Make sure the Area Light Power Button
is in the on position
Check that the unit has a full charge.
Recharge the unit if necessary.
Accessories
WARNING: Since accessories, other than those offered by
D
e
WALT, have not been tested with this product, use of such
accessories with this unit could be hazardous. To reduce the risk of
injury, only D
e
WALT recommended accessories should be used with
this product.
If you need assistance regarding accessories, please contact the
manufacturer at 1-888-394-3392 or CustomerService@dewalt12volt.
com.
Service Information
Whether you need technical advice, repair, or genuine factory
replacement parts, contact the manufacturer at 1-888-394-3392 or
CustomerService@dewalt12volt.com.
DXAEPS2_ManualENSP_101216.indd 25 10/19/2016 3:56:35 PM