Full Product Manual

English

Connectors and Cables (Fig. 3)

Double Barrel Charger

Connector (connects to

Clamps or Battery Terminal

Rings)

J. AC Plug

K. Battery Terminal Rings

L. Battery Clamps

I J

Preparing to Charge

1. Be sure the area around battery is well ventilated while the battery

is being charged.

2. Remove the battery completely from a boat/airplane or any confined

area before charging.

3. If it is necessary to remove battery from a vehicle to charge or to

clean terminals, always remove the grounded terminal from the

battery first. Make sure all accessories in the vehicle are turned

off, so as not to cause an electrical arc.

4. Clean the battery terminals, taking care to avoid getting corrosive

material in your eyes.

5. Add distilled water in each cell until battery acid reaches the

level specified by the battery manufacturer. This helps purge

excessive gas from cells. Do not overfill. For a battery without cell

caps (maintenance free), carefully follow manufacturer’s charging

instructions.

6. Study all battery manufacturer’s specific precautions, such

as removing or not removing cell caps while charging, and

recommended rates of charge.

7. Determine the voltage of the battery to be charged by referring to

the vehicle manual. This unit is for charging a 12 volt battery only.

CHARGER LOCATION

• Locate the charger as far away from the battery as cables permit.

• Never place the charger directly above the battery being charged;

gases from the battery will corrode and damage the charger.

• Never allow battery acid to drip on the charger when reading gravity

or filling the battery.

• Never operate the charger in a closed-in area or restrict ventilation

in any way.

• A marine (boat) battery must be removed and charged on shore.

To charge it on board requires equipment specifically designed for

marine use. This unit is NOT designed for such use.

DXAEWPC4_ManualENSP_Type2_010920.indd 8 1/9/2020 2:20:28 PM