Instructions / Assembly

English
8
•
•
Before storing air mover it should be cleaned.
Wrap the power cord around the carry handle on the top of the unit to
keep it untangled (Figure 5).
STORAGE
This Air mover is equipped with a motor thermal protection device. Once
activated, it can restart without notice. If it is triggered, turn switch to OFF
position, unplug unit and wait a moment before plugging air mover
back in and restarting it.
To clean the air mover, use a cloth dampened only with water and mild soap.
Never let any liquid get inside the air mover. Never immerse any part of the air
mover into a liquid.
Figure 5
THE AIR MOVER SHOULD BE STORED INDOORS.
CAUTION:
CAUTION:
TROUBLESHOOTING
unplug before disassembly or servicing.
WARNING:
All disassembly and repairs should be
WARNING:
ce.
WARNING:
If the supply cord is damaged, it must be replaced by
ns in
order to avoid a hazard.
PROBLEM SOLUTIONCAUSE
Unit will not run.
1. No power to unit.
2. Switch not on.
1. Plug unit in. Check circuit breaker.
2. Place in “ON” position.
Unit runs but Air
Mover makes
loud scraping
noise.
Unit runs but
vibrates
excessively.
1. Dirt build up on one side
of Air Mover blower wheel.
2. Severe jolt has bent
motor shaft.
Unit runs but
blower wheel
does not turn.
1. Contact customer service.
1. Contact customer service.
1. Blower wheel is jammed
against housing.
then shuts off
on overload.
1. Intake grille and /or
exhaust grille is
obstructed.
2. Motor bearings are failing
or motor has developed
an internal electrical fault.
1. Remove obstruction.
2. Contact customer service.
1. Unit has been severely
jolted causing blower
wheel to rub against
housing or housing to
deform.
1. Contact customer service.